Pop 'N Plug PNP417 with Custom Tabletop Surface

Overview:

This PNP417 with a custom tabletop surface is the best thing that’s ever happened to your conference room! Using your table cutout, the PNP417 is attached underneath, and when closed, the PNP417 matches the grain on the table perfectly.

Summary:

This PNP417 with a custom tabletop surface is the best thing that’s ever happened to your conference room! Using your table cutout, the PNP417 is attached underneath, and when closed, the PNP417 matches the grain on the table perfectly.

Altinex provides three pre-configured templates for the PNP417 cutouts: round, rectangular, and square. A simple press on the lid closes the unit flush with the tabletop.

The PNP417 design allows the connector panels to be easily installed. Just remove the top and slide the connector panels into place. In the open position, the PNP417 is functional yet maintains a smooth, clean appearance.

The PNP417 comes preconfigured with two standard DS901-120 sectional plates. Each plate includes the following connectors: two AC power, one 15-pin HD (video), two RJ-45 (UTP), one RJ-11 (modem) and one 3.5 mm audio. There are two plates and all connectors on the plates are female receptacles. Each signal connector is connected via a 6-foot cable to its corresponding male plug at the opposite end. The AC power cables are terminated with standard NEMA plugs at the end of 9-foot cables.

Features:

• Customizable to almost any table top
• Dual-sided connectivity holds up to eight connector plates
• Connector plates are fully compatible with PNP400& PNP500 series
• Smooth new look on all sides
• Round, rectangular, or square cut-out
• Simple, slide-in installation
• Opens/closes by pressing on top
• Gas spring lift mechanism
• Craftsman-milled edges create ultra-flat surface when closed
• Ships with 6 ft pre-terminated cables for quick installation