CC12 Remote Relay Module

Use an infrared remote to control your drapes, projection screen, or any other application that requires dry switch closures! The 1 Double-Pole, Double-Throw Remote Relay Module is a 5-amp, 30V DC-rated relay with four available contacts: two normally open, two normally closed. All that you need is a programmed universal remote and you'll be able to send IR signals to the relay module to open or close drapes, or stop them at any point in between. Provides "dry contact" closures for plasma lifts, screen drops, drapes etc.; One double pole, double throw relay, 5 amp/30VDC rated; Four contacts available: two normally open, two normally closed; IR input terminals IR code select switch; Requires 781ERGPS power supply and RC68X Programmer(Sold Separately)

FEATURES AND SPECIFICATIONS • One 6-terminal plug-in connector to make connection to the internal DPDT relay. • 5 Amp/30V DC relay contact rating. • 4-terminal IR input (S = IR Signal, CI = Control Input, G = Gnd, V = +12V) for connection of Xantech IR Receivers, Smart Pads, Connecting Blocks and other devices. • All plug-in connectors accept wire sizes from 24 to 12 gauge. • IR CONFIRM LED goes on only when an RC68+ (or RC68) IR command signal activates unit. • LED turns ON when N/O (normally open) contacts are closed and goes OFF when N/C (normally closed) contacts are closed. • Four RC68+ IR commands permit Pair, Toggle, and Momentary operation of the switching relay. • IR activated ON condition (N/O contacts closed) goes OFF if power is interrupted. • +3V to +30V DC 1 mA applied to CI terminal will switch unit, instead of IR, if desired. • Factory preset Group Code number: 50. • CODE SUB-GROUP switch allows a choice of 8 different groups of the four RC68++ commands that operate the CC12. This prevents mutual interaction in common IR systems when using more than one CC12 Also, internal E2 PROM can be set to different code groups, allowing up to 240 different IR code combinations if the system uses more than eight CC12's or in combination with SR21's. • Power: +12V DC @ 50 mA. Use the 781RG Power Supply for each CC12. If IR receivers or keypads are used on the same 12V line, use the 782-00 Power Supply. • Flanges, plus supplied screws, permits easy mounting to flat surfaces. • Dimensions: 5-1/4" x 2-3/8" x 1-7/8".