Lowell RPAK-810-72 8" Ceiling Speaker, Blackbox, Tile Bridge Combo

Overview:

Speaker system for recessed installation includes two (2) sets of ready-to-install speakers with factory-mounted transformers, grilles, enclosures, tile-bridges.

Performance:

General purpose paging and distributed music

Assembly Includes (Set of 2 Each):

• Driver (No. 810):  8 in. 15W dual cone with 10 oz. magnet, 54Hz–11.6kHz (±6dB) and 50Hz–20kHz (±6.6dB) frequency response, 97.9dB average sensitivity measured 1W/1M.

• Dual-Voltage Transformer:  25V/70V transformer with primary taps at .25, .5, 1, 2 and 5W.

• Steel Grille (No. WB-8):  Factory mounted to driver with welded studs. Installs to enclosure and T-bridge with four white screws (provided). White finish.

• Enclosure (No. 8XD4):  Heavy gauge steel with acoustic pad and four 1/2 - 3/4 in. knockouts for conduit. Punched lip for screw-mount installation of T-bridge. 10 in. diameter x 4 in. deep. White. Note: Does not include 8- 32 screws to mount enclosure to tile bridge. 

• Tile-Bridge (No. LBS8-R1): Transfers weight to ceiling support structure in suspended tile ceilings. Galvanized steel with 4 wire-tie holes for seismic anchoring. 23.75 in. long.

Compliance & Certification:

• Certified U.S. steel

• Made in the U.S.A. with global components

A&E Specifications:

The 8 inch speaker system shall be Lowell Model No. RPAK- 810-72 which shall include two 8" dual cone drivers with wired dual voltage transformers and mounted white steel grilles boxed with two enclosures and two tile-bridges to transfer the speaker assembly weight to the ceiling support structure in suspended tile ceilings. The driver shall have an RMS power rating of 15W and employ a 10oz. ceramic magnet and molded high fiber cone. Frequency response shall be 51Hz-11.6kHz (±6dB) and 50Hz-20kHz (±6.6dB) with sensitivity of 97.9dB average measured 1W/1M. The transformer shall be 25V/70V with primary taps at .25, .5, 1, 2, and 5W. The grille shall be steel with white powder epoxy finish. The steel enclosure shall measure 10 in. diameter x 4 in. deep with 1/2–3/4 in. knockouts for conduit and a white powder epoxy finish. The tile-bridges shall be 23.75 in. long galvanized steel with holes for seismic anchoring.